Manual Debris Removal

Device
D4K™
Pro XL™
Envision One cDLM™

This feature helps simplify the process of cleaning the material tray.

To remove debris from the material tray, complete the following steps:  

  1. Select Settings > Manual Debris Removal to open the tab.

  2. Set the required exposure time using the + and – icons.

  3. Select Expose.
    → The entire material tray area is exposed.

  4. Remove debris from the material tray by lifting the thin film of the exposed material.

  5. Proceed following the step-by-step for filtering material described on the Maintain Materials page, if needed.