Clean Dust

Device
D4K™
Pro XL™
Envision One cDLM™

Time needed: Approximately five minutes

Maintenance frequency: Weekly

Dust may accumulate on, near, or inside of the printer. Dust can build up on fans and vent holes. High levels of dust accumulation can cause the printer to overheat.

Important: To protect the internal hardware, the printer automatically shuts down if it reaches the maximum internal temperature of 49° C (120° F).
  1. Look around the vent holes on the left and right sides of the printer’s casing for signs of buildup. 
  2. Listen to the fan for inconsistency, stress, or obstructions when the printer is powered on. 
  3. To remove dust, power down the printer, disconnect the power cable and wipe the vents and fan with a microfiber cloth. 
  4. Look down through the safety glass under the material tray and check for dust or debris on the projector lens. If there is dust on the projector lens:
    1. D4K™ or Envision One cDLM™: Contact Customer Support for assistance.
    2. Pro XL™: See Clean Projector Lens.